Jan 03, 2026

How do I connect the backup power supply to the UPS main unit?

Leave a message

Steps to connect the backup power supply to the UPS main unit:

1. Equipment preparation: Confirm the backup power supply type (generator/battery pack), and ensure the output voltage matches the UPS input (220V or 380V); prepare matching cables (cross-sectional area ≥ 6mm²) and copper lugs.

 

2. Power-off operation: Disconnect the UPS mains input circuit breaker and turn off the UPS main unit; turn off the backup power supply, ensuring there is no power at the output (confirm with a multimeter).

 

3. Wiring method: Backup power supply output → UPS backup input port (labeled "BYPASS" or "GEN"); connect the live wire to L, the neutral wire to N, and the ground wire to PE (yellow-green wire); tighten the terminals (torque 30N·m).

 

4. Parameter settings: Enable "Backup Power Supply Mode" in the UPS menu, and set the switching threshold (switch to backup power 10 seconds after mains power interruption); the generator needs a start signal. Test: Simulate a mains power outage; the UPS should seamlessly switch to the backup power supply. After the mains power is restored, there should be a 30-second delay before switching back (waiting for the generator to stabilize and shut down).

Send Inquiry